How to cascate of two TS802
Hardware ready:
1, a DVI cable (DVI cable a turn two lines)
2, 2 linsn 802 send card
3, a ten-pin cable
the hardware connection
with ten pins traversing cascading up two to send a card, as shown in Figure 1.2
1
each TS802 have a red button, press the key set one to 1, set another card key unchanged. As in Figure 2.
2
Put the two cards into the computer’s PCI socket, with 1-to-2 DVI cable connect the two TS802 to the display adapter DVI port. As in Figure 3.
3
software setup
2 pcs TS 802 cascade can control up to 1600*1200 pixels, the two sending card have four signal output port: 1U1D2U2D, as shown in Figure 4.
Take Red key has not changed card as RJ45 1U1D, another card RJ45 is 2U2D
4
As every RJ45 control only 400 pixel in height, to get pixel higher than 400, use 1U start, 1u-1d-2u-2d, set CON file as:
Cable 1 connect to sending card 1u port, set as picture 5,
Cable 2 connect to sending card
According to the connect way set CON file, send card RJ45 with 400 points for each height, above 400 points with additional RJ45 port, push up to this first start from 1U, 1U-1D-2U-2D, sets the CON file are as follows.
Access from 1U cable 1 exit when you send a card, as shown in Figure 5, select 1th to send a card on the main line u line (1U)
2 connect the network cable when you receive a card, as shown in Figure 6 d, sent a card, select on the main line (1D)
3 connect the network cable when you receive a card: as shown in Figure 7, u choose 2nd to send cards on the main line (2U)
4 connect the network cable when you receive a card, as shown in Figure 8, d, sent a card, select the 2nd line on the main line (2D)
Specific practices in accordance with the wiring set, set up and sent to the receiving card and saved to the card on the line.